Yellow Bullet Forums banner

Engine Show and Tell

1.6M views 3.6K replies 879 participants last post by  scott foxwell  
#1 ·
wouls like to see pics of everyones engines- looking for some different ideas - thanks guys we did this on the nos section turned out great :p
 
#4 ·
Image
 
#13 ·
It's half and half. The hotside was originally a street kit built by HP Performance (www.turbochargedpower.com). It was then modified from a T4 flange to a T6 flange so I could run a large frame turbo, and the entire cold side was custom fab'd by a local shop (Fatal Performance). The frame rail also had to be notched to clear the large frame turbo, so it wasn't a bolt in affair.

Here's an older pic that's a little bit brighter.
 
#17 ·
It's half and half. The hotside was originally a street kit built by HP Performance (www.turbochargedpower.com). It was then modified from a T4 flange to a T6 flange so I could run a large frame turbo, and the entire cold side was custom fab'd by a local shop (Fatal Performance). The frame rail also had to be notched to clear the large frame turbo, so it wasn't a bolt in affair.

Here's an older pic that's a little bit brighter.
thanks for the info..thats where i want to stick my pt88..i been looking into kits..i'm just going to take a fox body kit and weld diff header flanges on it seeing i'm going with a lsx engine.
 
#59 ·
I see you are still a dreamer sold car for 550.00 for rent