$300. Carbs will need to be gone through. A lot of sbc tunnel rams are out there. I might be a bit low on the price since period correct gassers/gasser posers are popular.

 

The most I ever got for one was $275.00 for just the intake. And that was fully restored, looking like NOS (new).

I think you can still buy them.

By the way, your pictures don't work. YB isn't advanced enough technology wise to use attactments.

 

If you're logged in, click on them and they open in another tab. (for me anyway)

 

That manifold is great for a small cube engine like a street rod or weekend muscle car cruiser. It has the smaller runners and plenum box so you can run 390-450 vac sec carbs and not loose much low end torque.
Like others have said, the swapmeets are full of them so in decent shape, no cracks, all the threaded holes are good and the coolant passages haven't been eaten away you're looking at $200-275.

 

ok thanks a lot for the responses guys, I think I might go thru the carbs clean it up and sell it for him, thanks again

 

Don’t clean it up. The rat rod guys will actually pay more for original looking patina than cleaned, blasted new looking intakes.

Sell it as-is. Many guys will redo the carbs and not clean and detail them. Same thing, rat rodders. It’s the diamond in the rough look.

You should be able to get $300+ as it sits. No problem. In a swap meet feeding frenzy, those guys will pay even more.

 

I have one of the old breadbox tunnel rams for sbc and had people say i couldnt even give it away. It is the one that NHRA outlawed cause fuel would puddle around the runners which were higher than the plenum floor and a hiccup turned it into a bomb. Lol.

 

I have one of the old breadbox tunnel rams for sbc and had people say i couldnt even give it away. It is the one that NHRA outlawed cause fuel would puddle around the runners which were higher than the plenum floor and a hiccup turned it into a bomb. Lol.

A Ridgeway, or old Edelbrock?

 

Edelbrock. Not sure what the model number is. And OP i agree with whats been said in regards of cleaning the TR. Alot of guys want the dirt, grime and patina left alone that way at the cruise ins they can brag they have "original" and "old school" parts and not new etc.

 

350.00

 

haha sounds good to me, I'll leave it as is! thanks everyone

 

Anyone who has seen this Engine Masters video of the Eddy TR1Y would want one! I would like to do this for a nice street engine!

Dave

 

Anyone who has seen this Engine Masters video of the Eddy TR1Y would want one! I would like to do this for a nice street engine!

https://www.youtube.com/watch?v=-XjDq2DcZk0

Dave

That's impressive.

 

Pics work just fine for me. I will give 300 for it as is. PM me if interested.

 

'Whatever" the market will bear.......

Pick a number, and put it on it.

Just Remember, you can always come down in price, but never go up.