Yellow Bullet Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
314 Posts
Discussion Starter · #1 ·
I have a set of c3 heads that are older castings designed for individual rocker stands. I was once told that the heads can be machined for one piece stands, and recently found a set of jesel pro-series rockers with one pice stands for a good deal. I would like to know if this is possible before I throw away money? Any help and advice is apppreciated.
 

·
Registered
Joined
·
8,823 Posts
Yes they can be milled for the one piece stands.. Dont waste your money on the pro series and buy a set of J2K's...
 
1 - 2 of 2 Posts
Top