Yellow Bullet Forums banner
1 - 4 of 4 Posts

·
King Shit on Turd Island
Joined
·
33,367 Posts
Discussion Starter · #1 ·
Hey guys, I remember seeing a low profile 4th Gen torque arm, but I don't recall where I saw it or who makes it. Anybody out there got a clue as to what I'm talking about and able to clue me in?
 

·
Registered
Joined
·
5,494 Posts
Not sure about the low profile model, I am aware of a short torque arm though... get in touch with "madman" (here @ YB) aka Brian at http://www.madmanandcoracing.com/. He is the go-to 4th gen suspension guru.

BMR, UMI and Spohn are other manufacturers of 4th gen suspension parts. I have installed components from all of these companies and they work quite well in the cars I've been involved with.

g
 

·
SOFA KING WHAT?
Joined
·
43,675 Posts
How about the stuff from Moser for use with the M9 rear?
 

·
King Shit on Turd Island
Joined
·
33,367 Posts
Discussion Starter · #4 ·
Not sure about the low profile model, I am aware of a short torque arm though... get in touch with "madman" (here @ YB) aka Brian at http://www.madmanandcoracing.com/. He is the go-to 4th gen suspension guru.

BMR, UMI and Spohn are other manufacturers of 4th gen suspension parts. I have installed components from all of these companies and they work quite well in the cars I've been involved with.

g
I've got a BMR right now and I need to have the crossmember redone so I can lower the car. I was just curious to see if the crossmember that I had seen before would allow me to lower the car without having to modify the trans tunnel to clear the torque arm.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top