Yellow Bullet Forums banner
1 - 16 of 16 Posts

· Registered
Joined
·
143 Posts
Discussion Starter · #1 ·
A friend of mine was asked to look at a car and see if you can find the cause of a broken rocker arm. Upon disassembly he notices the square end of the pushrod was installed on the rocker arm side and the hardened rod end was on the lifter side..

He tried to tell the installer the pushrod was installed upside down but he immediately got upset and said well it's a "Proline" engine and they told me to install it that way because it's a street car. If it was a race car it would be installed the other way.. He tried to tell him that proline would never say something like that and maybe you misunderstood them but he wasn't hearing it...

Can you guys clarify this for him so maybe the others involved don't actually believe this idiot.. :)
 

· ...failure to communicate
Joined
·
4,872 Posts

· Registered
Joined
·
1,952 Posts
Yes, but what if this was a street/strip car? Would you install that sumbitch sideways???
 
1 - 16 of 16 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top