Yellow Bullet Forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
3,483 Posts
Discussion Starter #1
Well I went last Friday and managed a 10.40 @ 135 with a 1.71 60'.. The car was real lazy above 5500 rpm.. Monday I found a burned wire and the plug was fouled.. Put a new set of plugs in and a new set of wires.. I also went and got a alignment, sense I've lowered it and never got around to aligning it.. Well first pass I get a good burn out in, pull up and stage.. Bring it up to 4200 and dump the clutch.. It tried to dead hook and something in the rear didn't like it.. I loaded it on the trailer and got her home.. I guess tomorrow I'll get her on stands and figure out what gave.. I really wanted to get a good pass in before putting in this Ed Curtis bumpstck, but oh well..
 

·
Registered
Joined
·
4,488 Posts
The joys of a stick car. LOL

What is the setup?

Tim
 

·
Registered
Joined
·
3,483 Posts
Discussion Starter #4
08 c6z
Marcella intake NW 102mm tb
Stock LS7's ported and angle milled to 51cc by WCCH
Bullet cam
2" AR headers
345-35-18 M/T dr
Car made right at 650/550 and runs on E85
 
1 - 4 of 4 Posts
Top