Yellow Bullet Forums banner
1 - 4 of 4 Posts

·
Registered
Joined
·
4,724 Posts
Discussion Starter · #1 ·
i posted this in the tech area and not much help.
i have not flow tested my pump/intercooler but will soon.the car should be running soon.i have results from a[3] dyno pulls.air was 270* before/130* after the I/C with a gardin hose flowing on the dyno for the I/C.i figure 30psi at 65* for the water.
i have a flojet pump[150GPH at 45psi]3/4 hose ID.
how can i restrict the flow? maybe a ball valve in line to the I/C[before/after?]
your thaughts,ideas please!
THANKS!
the engine made 998HP at 6300 RPM
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top