Yellow Bullet Forums banner
1 - 2 of 2 Posts

· Registered
1,161 Posts
Discussion Starter · #1 ·
I have a 38mm on right now and I plan to upgrade. The flanges on the WG is the not the Vband flange. I've seen adapters for the one side of the flange but not for the other. Would it be better just to weld flange welded on?

Can you go too big on WGs? I have a 76mm Precision billet turbo, with .96 exhaust, on a 322 mod motor. I'm installing a ams1000 with c02 and need to upgrade my WG. I was looking at some of the 60mm for sale in the for sale section. Would those be too big? I plan on running up to 25psi.
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.