turbo question

777 Views 9 Replies 4 Participants Last post by turbo cutty, Jul 6, 2009

turbo cutty

Discussion Starter · Jul 2, 2009

I got a 406 sbc blow thru I need to know if I can use a t3 flange on each side of it the turbos are t6 I was thinking a adaptor plate on it...

Save

1 - 5 of 10 Posts

turbo cutty

Discussion Starter · #3 · Jul 2, 2009

the headers are t3 so i was thanking of cutting them or just to use a plate that i have
or will i lose power if i use the t3 flange on it......

it is a twin turbo system

Save

turbo cutty

Discussion Starter · #6 · Jul 3, 2009

thanks guys ...i though so...

Save

turbo cutty

Discussion Starter · #8 · Jul 6, 2009

Sickcivic said:
I hope you are not trying to hang T6 turbo's off the headers!! Cut those t3 flanges off, weld on some 3" v-bands and make some mounts for your turbos, then connect your piping! Good luck with it!

going to make some mounts for the turbos they weight more then a m.f. ....
one more question 1 5/8 pipe is it fine coming out of the head

Save

turbo cutty

Discussion Starter · #10 · Jul 6, 2009

thanks

Save

1 - 5 of 10 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month