Yellow Bullet Forums banner

turbo question

776 Views 9 Replies 4 Participants Last post by  turbo cutty
I got a 406 sbc blow thru I need to know if I can use a t3 flange on each side of it the turbos are t6 I was thinking a adaptor plate on it...
1 - 2 of 10 Posts
I hope you are not trying to hang T6 turbo's off the headers!! Cut those t3 flanges off, weld on some 3" v-bands and make some mounts for your turbos, then connect your piping! Good luck with it!
Try to match up to the size of the ports in your heads! Those headers have worked in many turbo setups so try it since you already have them!
1 - 2 of 10 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.