Turbo oil feed
I've just got a new engine and need some help deciding where to pull the oil for the turbo. SBC Iron Eagle Block, 418CI. The oil feed is going into the rear port in the block. The rear lifter feeds are blocked completely so all the oil goes through the mains first. Then I have the front lifter feeds restricted to .100.
In my past engines I teed off the oil pressure port to feed the turbos, but with this engine I would rather not take oil away from the mains. Can I use the front oil feed into the block as my feed for the turbo? This way the oil would go through the mains and then feed the lifters and turbo after the mains.
Thanks
In my past engines I teed off the oil pressure port to feed the turbos, but with this engine I would rather not take oil away from the mains. Can I use the front oil feed into the block as my feed for the turbo? This way the oil would go through the mains and then feed the lifters and turbo after the mains.
Thanks
1 - 1 of 4 Posts
1 - 1 of 4 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Yellow Bullet Forums
A forum community dedicated to drag racing drivers and enthusiasts. Come join the discussion about racing, builds, pro mods, hot rods, events, turbos, nitrous, superchargers, and more!
Full Forum Listing
Recommended Communities
