Yellow Bullet Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
4,121 Posts
Mine comes off the front feed. Just because the hose would be shorter.

Don't forget to plug the 1/4 holes in the rear lifter galley's. You want the oil to be forced towards the front of the block before oiling the lifters. I run .125 restrictors in the front. Just drilled a 1/4 plug with a .125 bit.
 

·
Registered
Joined
·
4,121 Posts
Dusty,
I believe the machine shop guy plugged them. When I got the block back I noticed quite a few holes plugged. I have mine set up to feed off the front like yours, Just stepped it down to -4 but kept on hearing about this rear one.Thanks for the info.

Anyone used the braided teflon hose for turbo feed?
Same here. -4 feed from the front with a -12 return to the pan.

The plugs will be inside the larger plugs that you see on the back of the block on both sides of the cam plug. Before you go to far I'd pull the outer plugs out just to check and make sure the inner 1/4 plugs are installed.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top