Yellow Bullet Forums banner
1 - 4 of 4 Posts

·
Registered
Joined
·
2,290 Posts
Discussion Starter · #1 ·
2 part question:

Can braided teflon hose be used for oil feed to the turbo? I have like 5 feet of -4 stuff id like to use.


Where is the best place to pick up oil for the turbo feed side? (Dart Little M) The fitting by the oil filter & or up front just under the front of the intake. Been told to use either??
 

·
Registered
Joined
·
2,290 Posts
Discussion Starter · #4 ·
Dusty,
I believe the machine shop guy plugged them. When I got the block back I noticed quite a few holes plugged. I have mine set up to feed off the front like yours, Just stepped it down to -4 but kept on hearing about this rear one.Thanks for the info.

Anyone used the braided teflon hose for turbo feed?
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top