Yellow Bullet Forums banner
1 - 5 of 5 Posts

·
Registered
Joined
·
508 Posts
Stainless works was making a header a few years ago. It was your typical upswept design like most guys run. At that time they were around $1450 made from 304.
 

·
Custom Engine Shop
Joined
·
3,812 Posts
DIY in 16ga mild steel with 1/2" flanges for less than $400.
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top