Yellow Bullet Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
1,441 Posts
Discussion Starter #1
On a PG, how far should the yoke slide into the back of the trans? I think my driveshaft may be too short. The yoke is about 4" long and 2" of it is in the trans. Tomorrow I'm gonna take the rear of the driveshaft loose, slide it forward all the way, mark it, hook it back up, and measure how far from all the way in it is.
 

·
Registered
Joined
·
1,441 Posts
Discussion Starter #3
Shit!!! It's 1" too short. That sucks
 
1 - 3 of 3 Posts
Top