[sic_rt]

Throwin together my new motor and it is built of parks that were previously used so I have no paperwork. Can anyone tell me what I should torqe my rods to and main caps? oliver billet 6.250 and dart block with billit 4 bolt mains on all caps. Are the outer spayed bolts a different torqe setting.What kind of crank clerances should I have?THANKS

 

[vegaman924]

the bolts on the rods have #s on them,call oliver with that #s, on the mains 65 outer 70 inner 35 on the 3/8 bolts on 1 and 5 with moly lube i like .002 -.00225 on mains and .0025 on rods

 

[Seattle_Mike]

You might consider using a stretch gauge for the rod bolts.

 

[ThisGuyGone]

I use oliver billet rods torque to 35 ftlbs then stretch gauge to 45 degrees..3/8 bolts..

 

[Seattle_Mike]

45 degrees? I do it to thousandths of an inch.

 

[RCM Racing engines]

Think he means Torque + Angle.... if it's the silver WSB oliver bolt, 7/16" it's 30 ft lbs + 40-42 degrees
compare it to a stretch gauge and see it's right on the money.....

 

[ThisGuyGone]

Think he means Torque + Angle.... if it's the silver WSB oliver bolt, 7/16" it's 30 ft lbs + 40-42 degrees
compare it to a stretch gauge and see it's right on the money.....

Yes that's right..