Yellow Bullet Forums banner

Strange nodular center section carrier bolts bent

789 Views 3 Replies 3 Participants Last post by  CurleysRacecars
Strange is closed today but I wanted to put my center section back in and I noticed when I was putting two of the bolts back into the housing they were bent a little. So can I just replace them with grade 8 and be ok or should I order the bolts from strange?
1 - 4 of 4 Posts
As long as you know the thread I would think you should be fine with grade 8's. I doubt Strange uses grade 10 or NAS bolts in their stuff. Good luck man!

Are you talking about the 3/8" bolts that go into that faceplate of the housing? If so, I have some if you need them.
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.