The spool in the Ultra case is different than the standard 40 spline spool. The Ultra case spool is wider and uses shorter axles.
You may be able to shorten your axels.
You may be able to shorten your axels.
Strange 40 spline axles into new spool
Installed a new "ultra-case" Strange center section. Using existing strange 40 spline axles.
Axles go into the new spool about 1/2" and very tough get in further. Been hitting it with a wooden mallet. Not making it move much. Does it really need a good beating to get it in? Like a sledge?
I don't think there is a mis-match in the axle/spool as it's all strange stuff.
Axles go into the new spool about 1/2" and very tough get in further. Been hitting it with a wooden mallet. Not making it move much. Does it really need a good beating to get it in? Like a sledge?
I don't think there is a mis-match in the axle/spool as it's all strange stuff.
1 - 1 of 5 Posts
1 - 1 of 5 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Yellow Bullet Forums
A forum community dedicated to drag racing drivers and enthusiasts. Come join the discussion about racing, builds, pro mods, hot rods, events, turbos, nitrous, superchargers, and more!
Full Forum Listing
Recommended Communities
