Yellow Bullet Forums banner

1 - 12 of 12 Posts

·
Registered
Joined
·
530 Posts
Discussion Starter #1
Anybody have any recommendations on where to get the Stahl patterned plates? I've got new Kooks/ SBC FOX conversion hedders that came with adaptor plates. Problem is the exhaust ports are too large for my Iron Eagle ports. Huge gap at the bottom of the opening, right above the headbolt bosses.
I've called Kooks and keep getting put on "hold" for 15 minute intervals. Was hoping someone might have already dealt with this or offer some insight on where to find "smaller" exhaust opening versions in these plates.
Appreciate any input.
 

·
Registered
Joined
·
530 Posts
Discussion Starter #4
To be sure; is there any other pattern out there I could be confusing this one with? Stahl is pretty much an industry standard on adapting std 23* exhaust port lay-out, correct?
Thanks again.
 
1 - 12 of 12 Posts
Top