Yellow Bullet Forums banner

1 - 7 of 7 Posts

·
Registered
Joined
·
2,010 Posts
Discussion Starter #1
I have a 40 spline strange axle and a 40 spline moser spool will this work or is the spline cut different for each company
 

·
Registered
Joined
·
1,249 Posts
I cant say for sure, but i have mismatched axles and spools from different companys before without a problem. Never messed with any 40 spline stuff though
 

·
Registered
Joined
·
305 Posts
A call to Strange would be the safe approach, I'm not certain about Moser but I know MW uses a different angle on their splines. Mixing different angles is not recommended.
Carl
 

·
Registered
Joined
·
2,010 Posts
Discussion Starter #7
just got off the phone with both companys and the pressure angle is 45 degrees FYI so this is good news
 
1 - 7 of 7 Posts
Top