Yellow Bullet Forums banner

1 - 16 of 16 Posts

·
Registered
Joined
·
682 Posts
Discussion Starter #1
I need a new set for my pistons, wiseco part #6398RA07

And further more, how do you put em in? if you need more info tell me.

if someone could point me in the right direction that would be awesome.
 

·
Registered
Joined
·
213 Posts
Spiro locks are like a flat coil spring. To put them in you start one end in the groove and work the coils around till it's all in. An o-ring pick or scribe helps. Make sure you do this on final assembly because the are a pain to get back out.
 

·
Registered
Joined
·
410 Posts
They arent that bad once you figure out the first 1 or 2. Removing them was performed with a nail and a small flat blade. Actually came out really easy for me. Maybe I just got lucky..
 

·
Registered
Joined
·
4,731 Posts
Thats the way to get them out. I use a scribe but what ever works for ya do it. And your right there they're not that bad once ya get the hang of it.
 

·
Registered
Joined
·
6,968 Posts
I hate those things. Don't re-use them, you can get the replacements cheap direct from Wiseco.
 
1 - 16 of 16 Posts
Top