Yellow Bullet Forums banner

1 - 6 of 6 Posts

·
Registered
Joined
·
2,835 Posts
Discussion Starter #1
Brand new parts. They were the wrong ones for my build. I needed a much larger dish.

Speed pro forged pistons lw2605f
4.060 bore
1.425 compression height
-12cc dish

.927 taper wall wrist pins
Tool steel
2.500 length

With wire locks

1/16 moly, 1/16 Napier, 3/16 standard rings

As you can see on the pictures the valves made a tiny bit of contact on 4 of the 8 pistons

If the valves were your peepee, and the pistons were a vaginer, your wife wouldn't even consider the contact cheating. It will affect nothing on your build.

This pile of paperweights cost me $998 all in with shipping and tax. Purchased from j&l engines in Lancaster, New York.

Please, help me recoup some of the money so I can finish the project. It's been 12 long years.

$650 free shipping for all of this. Help a brother out!
 

·
Registered
Joined
·
2,835 Posts
Discussion Starter #4
60814


These 2 have the most noticeable marks on them. See the top of the valve relief on the right
 
1 - 6 of 6 Posts
Top