Yellow Bullet Forums banner

1 - 9 of 9 Posts

·
Hit Em In Da Mouf Racing
Joined
·
15,445 Posts
Discussion Starter #1
A MLS multiple layer head gasket for a big block chevy opposed to 1017 felpro. I running aluminum heads with 12to1 compression , stock deck block . I've been seeing a lot of advertising for these gaskets and was just wondering , since the manufacturers are saying this eliminates block o-ringing and makes a better seal . I would like to know what you guys opinions are , thanks !;)
 

·
Registered
Joined
·
10,404 Posts
Unless your running boost or butloads of nitrous there not needed
Posted via Mobile Device
 

·
Hit Em In Da Mouf Racing
Joined
·
15,445 Posts
Discussion Starter #3
Unless your running boost or butloads of nitrous there not needed
Posted via Mobile Device
I have a 200 shot hitman , wut you think , probably not enough nitrous to warrant using them , right ? And thanks
 

·
I kill parts
Joined
·
10,370 Posts
For a clean 200 hit, the performance composition gaskets should be fine.

We've run north of 30psi and over 500hp worth of spray(sepreately of course) on the MLS gaskets and had no problems with them.
 

·
Registered
Joined
·
2,064 Posts
I switched over a couple years ago from the regular Felpro. Never had issues, but my motor guy said these was "better". Only thing better so far is the PRICE!!! Daaaayum! (double the cost of Felpro)

My motor is about like yours, nothing super special and no adders. I guess they are nice insurance(or just upgrade) but wonder sometimes.
 

·
I have a liter of cola
Joined
·
7,101 Posts
1 - 9 of 9 Posts
Top