Yellow Bullet Forums banner

1 - 1 of 1 Posts

408 Posts
Discussion Starter #1
I have a autometer pro comp ultralite electric fuel pressure gauge and i would like to also use the same sensor for datalogging fuel pressure on the XFI.

That being said, the gauge has 5 wires coming out of the black 10 pin plug, (2 for powering the gauge, and 3 for the sensor). I was wondering if one of the empty pinouts are for a "signal out" like with the speedometers or if i will have to splice into the purple signal wire?

I hope this makes sense and someone can give me some guidance.

1 - 1 of 1 Posts