Yellow Bullet Forums banner

1 - 7 of 7 Posts

·
Embalmer
Joined
·
1,335 Posts
Discussion Starter #1
Assuming I should bolt down to a pallet and send that way.

Any suggestions.


Gonna be a SBF so somewhere in the range of 350-425lbs without the pallet.

Thanks Dan Smith
 

·
Registered
Joined
·
454 Posts
The last one I did like this I made a crate with a cradle for the short block. I wrapped the short block and heads separate. In the crate was short block, heads, intake, headers and a procharger set up. It all made it just fine. The thing I like best about crates is you know it aint gonna fall off and someone cant mess with it with out opening the crate. It's a little more work and cost but well worth it.
 

·
Embalmer
Joined
·
1,335 Posts
Discussion Starter #5
I have no problem making it secure just didnt know if it was going to require a lift gate or forklift being as I dont have one to load the pallet or crate. Just looking at options. I would prefer to keep the heads off and just bolted down next to the motor so the height isn't a factor.

Thanks for the suggestions. I will call around and ask.

Dan Smith
 

·
IN THE FRONT
Joined
·
4,015 Posts
unishippers, they are a brokerage firm that makes all of the frieght companies compete for your business.
Best I have ever delt with and very friendly!
 
1 - 7 of 7 Posts
Top