Yellow Bullet Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
4,731 Posts
I always use teflon scarf cut rings. Is it a turbo spline or p/g spline? If its a turbo spline does it have a support bushing in the stator support or does it have a support in the converter? Maybe post a pick of the input shaft up on here if you can.
 

·
Registered
Joined
·
4,731 Posts
Ok, Try the scarf cut rings. Pack assem. grease into the ring groves and put the teflon rings on it. They wont break!LOL!
 
1 - 2 of 2 Posts
Top