Yellow Bullet Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
Just a question to some of you that may have any tricks up your sleeve to seal mickey thompson 32x14-15 bias ply slicks when using beadlocks? I just purchased a brand new set of billet specialties single beadlock wheels and a brand new set of MT slicks but I have noticed they have been loosing air a lot faster than my old set of wheels and tires with rim screws... I used Palmolive dish soap on the beadlock side of the tire to see if that would help, but I have seen no improvement. any tips or tricks would be greatly apprciated!
 

·
Registered
Joined
·
629 Posts
Soap the up and see where the leaks are. Sidewall? Then they need more soap on the sidewalls. I use two coats.
Doug
 
1 - 2 of 2 Posts
Top