Yellow Bullet Forums banner

1 - 7 of 7 Posts

·
Registered
Joined
·
38 Posts
Discussion Starter #1
adding an aero hood scoop that will be mounted directly on top of my terminator injector. i have read to use a tray to seal the scoop , but where the scoop meets the windshield, do i leave it open in the back at the windshield or seal it? and if i seal it, do i leave a few holes to allow an occasional backfire when starting from blowing up the scoop. thanks for your help. a few pics would be awesome
 

·
Registered
Joined
·
496 Posts
Mine is fully open at the rear - but fits the screen closely.
I like it because you can see whats going on under the scoop.
Any problems and you can shut everything down quicker.
 

·
Registered
Joined
·
829 Posts
i sealed mine up. i noticed a small increase in mph. i trimed a piece of aluminum and glassed it in. Prior to that it was open. when it was open i found a real advantage to being able to look through the scoop to see where i was going while navigating the pits. good luck. let me know if you need some pics posted.
george
 

·
Registered
Joined
·
159 Posts
Mine is all sealed. The pro stock guys have spent allot of time and money on this. You see new designs all the time. I think at high speeds is where you can benefit.
 
1 - 7 of 7 Posts
Top