Yellow Bullet Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
989 Posts
Discussion Starter #1
I want to run reverse cooling in my sbf but I would like to fill the water passages in the block and the head so that if the head lifts under boost it doesn't pressurize the coolant system. I am also looking to run a copper head gasket so i would also need the o-rings installed in the head and the block receiver grooved. Does anyone know of a machine shop that can close up the water passages and take care of the rest of the machine work? I would prefer some one in the Northeast.

Thanks
 
1 - 3 of 3 Posts
Top