Yellow Bullet Forums banner

SBC rocker arm question

2059 Views 6 Replies 3 Participants Last post by  beebemotorsports
i have a set of dart iron eagle 230 heads and am using a set of offset lifters.
would it be ok to run a set of non offset rockers with guide plates.

they would be a 1.5 ratio with 7/16 studs
1 - 1 of 7 Posts
Actually comp cams makes a guide plate just for this head.

Isky makes the "sliding" guide plates that your referring to Chris.

tom cowle

PS if you use these heads, fill in the dip in the intake runner, the engine will love that.
1 - 1 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.