Yellow Bullet Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
22 Posts
Discussion Starter #1
OK GUY'S Heres the question. I have a set of BME 426 rods that are 6.598 long on the centers and a set od Ross pistons that are 1.398 on the compression height for a total of 7.96.The bore of the pistons is 4.530, The heads I have are a 118 cc chamber. My question is, is there a crank that will work with this set up and if so what block height will work with this set up if any?
I picked these up on a great deal and want to use them if possible. I will buy a new set of rods if I have to but would like to use these if possible.
THANKS A MILLION
 

·
Registered
Joined
·
4,391 Posts
10.200 deck
4.375 stroke
6.598 rod
1.398 ch
piston will be in the hole .017 buy a .050 minimum gasket of your choice & you'll have a 564cidBBC
 
1 - 2 of 2 Posts
Top