Yellow Bullet Forums banner

1 - 1 of 1 Posts

·
Registered
Joined
·
643 Posts
Discussion Starter #1
posted a thread about rings and bearings and have been looking at different options.
Is there a difference between the tnt and hellfire?
also as far as coated bearings all I have seen is speedpro durashield and clevite triarmor for rods, also it shows .001 extra clearance
would I want this or just standard?
prob should've had the guy thats gonna do the motor do all of this but have had to do everything as funds allowed so getting everything together before I take it to him


which of the rings and which bearings or is there any difference between those? If this is not the coating everyone is talking about can you point me in the right direction
 
1 - 1 of 1 Posts
Top