Yellow Bullet Forums banner

Ring gap

2K views 17 replies 8 participants last post by  prost63vette 
#1 ·
My motor's in the shop and all the machine work will be done next week what should the ring gap be for the rings the motor its a 512ci mopar with a 88mm turbo and C&S blow thru setup.

Thanks Mike
 
#6 ·
like he said...it depends on what the piston manufacturer recommends for your application....and they all like it different...pistons should have came with a gap sheet
gives you what they recommend times your bore size.....if not give them a call....

kinda thought this was basic common knowledge....
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top