Check the vent to start, if it is blocked then that will cause the seal to leak. Do you know which of the 3 10 bolt GM axles you have? 7.5 - 8.2 - 8.5?
rear end leak
I had a shop set my new gear up and posi unit gm 10 bolt i got it home i bolted up than over night the fluid was leaking from the pion seal or somewhere by the front all i did was put fluid in it and it leak its a new seal everythings new in side any ideas thanks
1 - 2 of 7 Posts
So it's not the seal leaking, it's the addded slop in the two splines. I rarely come across it but it does happen. Make sure not to over tighten the pinion nut, mark it and put it back to where it was.
1 - 2 of 7 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Yellow Bullet Forums
A forum community dedicated to drag racing drivers and enthusiasts. Come join the discussion about racing, builds, pro mods, hot rods, events, turbos, nitrous, superchargers, and more!
Full Forum Listing
Recommended Communities
