Yes, steam vent into side of surge/fill tank.
Restrictors go where thermostat was.
No, I haven't driven this one yet but have done 4-5 rear mount setups before.
Yes, steam vent into side of surge/fill tank.
Restrictors go where thermostat was.
No, I haven't driven this one yet but have done 4-5 rear mount setups before.
There's been some interest in this in a few other threads and in PMs, so I'll ramble on a bit about it here. Any questions, comments, advice, ridicule, etc, are always welcome. :)
This is the same concept applied to diesel motors, and different from twin turbo, sequential turbos, etc. Diesels...
If you were building a base for a tt bbc build. Conventional headed 2500+ hp capable which block would you choose? Hipped aluminum, or cgi iron, or just a billet capped dart M?
Like the idea of aluminum and I have seen many engines in the power range. The lbs saved would be nice since we are...
What’s the best size turbo for a built 331 dart, forged internals , Tfs 190 twisted wedge heads, f cam air to air cooler, bs3 computer on 93 octane gas? I’m hearing people making 750 to the tires on 93 pump. I was looking at the new precision ls turbos like the 7675, 82 and 84. This is just a...
New to Holley EFI Should I be running a iac throttle body or I was looking at the Holley 105 mono blade non iac and just run alpha-n idle it’s a drag race only car on methanol single turbo setup but it will be drivin to the lanes and back . What’s the better way ?
A forum community dedicated to drag racing drivers and enthusiasts. Come join the discussion about racing, builds, pro mods, hot rods, events, turbos, nitrous, superchargers, and more!
boostedbowtie · updated 
Kjewer1 · updated 
izcain · updated 
