Yellow Bullet Forums banner
1 - 3 of 3 Posts

·
Embalmer
Joined
·
1,335 Posts
Discussion Starter · #1 ·
Looking at my Hogan's sheetmetal manifold last night and wondering if I should polish it or not. Yes it needs a good cleaning anyway.

Any pros or cons just wondering.

Dan Smith
 

·
Registered
Joined
·
1,403 Posts
Sheet metal intake should be easy, polished a edelbrock cast tunnel ram nightmare and a half but did look good . Litely heat with the oxy first before you start polishing will save you have the effort .
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top