Yellow Bullet Forums banner

1 - 11 of 11 Posts

·
Registered
Joined
·
2,987 Posts
Discussion Starter #1
Does anyone make a convertor/pilot bushing for a SBF/powerglide when using a 1/4'' midplate? I have several laying around that work without a midplate but I haven't been able to find one that's a 1/4" longer for use with a midplate? I will send the convertor off to have the drive cover changed to accommodate the midplate thickness if that is my only option, but i'd rather not since I will be having a custom convertor built before long anyhow. Thanks
 

·
Registered
Joined
·
2,987 Posts
Discussion Starter #3
I am considering that, I am currently at work looking for a piece of stock the correct size, if I can find some, i'll chuck it up in my lathe and see what I can come up with.
 

·
Registered
Joined
·
2,987 Posts
Discussion Starter #8
Best to make the converter pilot. 250" longer then add the adaptor ring as is.


Hutch
Thanks, that would've been my next question, what side to add length to.
 

·
Registered
Joined
·
2,987 Posts
Discussion Starter #9

·
Registered
Joined
·
2,916 Posts
Best to make the converter pilot. 250" longer then add the adaptor ring as is.


Hutch
Both my TSI and ATI converters have screw on pilots. I just did a quick test fit then called and ordered one with the extra length I needed.
 
1 - 11 of 11 Posts
Top