I need an Exhaust Wheel for my near new 76/75 Unit that ate a Spark Plug.
I'm having trouble locating parts here in AUS with one character trying to slide in a Chinese Unit.
Happy to Ship Core over to get the Job done right.
Ive narrowed my choice down to either Borg Warner EFR 6258 or Garrett GT2860R. Both match up extremely well on the compressor maps for my application. The Borg being better at high pressure ratios above 30 lbs/min. I am leaning towards the Borg due to "Faster spooling" (internet hearsay) and...
I have read the instructions pertaining to this. And it looks pretty good doing a test run in the shop, but not so much during a run. I'm using co2, dual mac valves, controlling two gates. Dome pressure sensor is "remote" mounted on a 4" long 1/4" DOT tube just to isolate it from the heat and...
I would like to ask you guys if anyone have delt with them and how do they treat their customers when in comes to answering questions and emails or phone calls.
I am interested in the 24-b heads that they made but in the same time I don't want to deal with someone based on old reputation and...
So trying to figure this out, just had the car on the dyno, and the new engine combination is off by 200 hp, at 14 psi from the old combination, and should've made more than the old combination. 383 sbc, twin vs racing 66/67 billet wheel, .84 t4 flange, air to air intercooler, Holley 4500 super...
A forum community dedicated to drag racing drivers and enthusiasts. Come join the discussion about racing, builds, pro mods, hot rods, events, turbos, nitrous, superchargers, and more!
Third Gen Racer · updated 
FATI · updated 
