Yellow Bullet Forums banner

O2 sensor location..

2K views 5 replies 5 participants last post by  bad466 
#1 ·
Getting ready to start putting my drivetrain in and want to have my headers ceramic coated. Where should I put the bung for my o2 sensor, in the collector or the exhaust pipe?
 
#3 · (Edited)
If this is a race only piece with open collectors, I would recommend in a primary tube (12-15" from the head). With open collector you get back pulses of clear air which gives false lean readings. Also some collectors leak where the primaries slip in.

At this point do both and you are covered. Put one in each collector and one in #1 and #8 12-15 inches from the cylinder head.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top