Yellow Bullet Forums banner
1 - 8 of 8 Posts

·
Registered
Joined
·
88 Posts
Discussion Starter · #1 ·
What should a 550 rwhp small block with 300 horsepower shot stall to on the trans break? I cant get the car to leave its like it leaves in second gear until it gets out about 300feet and then takes off. Its got a 182 gear set in the glide any info will be appriciated.
 

·
Banned
Joined
·
18,113 Posts
Knock on a lot of wood, in fact, go over to Home Depot or Loews right now and knock on every piece you can find (wood that is!).

I watched a 500hp motor with a 200hp shot on it put just about everything inside the trans right on the starting line one night. He had been racing that trans for years, always pulled it apart every year to make sure it was still good. Swore to everyone that he didn't need no straight-cut junk! Well, guess what he has now: A trans from Trans Specialties with that straight-cut junk and he's thrown a lot more at that one since.

Saw another come apart on the top end in the traps, trans broke sooooo bad that the entire trans minus some of the bell housing area came out of the car and he ran it the fuck over! Shoulda saw what that looked like, what a hell of a ride! Even put a hole in the track that night, besides the floorboards of the car!

Wish you luck.
 
1 - 8 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top