Yellow Bullet Forums banner

Status
Not open for further replies.
77941 - 77960 of 117827 Posts

·
www.ULTRA-CARBON.com
Joined
·
12,739 Posts

·
Registered
Joined
·
657 Posts
it would proly work for a template. cant remeber what brand these were either. its a mullis digger.
obw sorry for buttin on on yer convo, been meaning to ask you as your not that far from B.C.
 

·
www.ULTRA-CARBON.com
Joined
·
12,739 Posts
it would proly work for a template. cant remeber what brand these were either. its a mullis digger.
obw sorry for buttin on on yer convo, been meaning to ask you as your not that far from B.C.
I can make you one off your part that matches your part exactly, but between the cost of making the mold and making the part for you, it would be waaay, waaay cheaper for you to try and chase down where it came from and buy one from them.
 

·
www.ULTRA-CARBON.com
Joined
·
12,739 Posts
ok thanks, I'll see what I can find. I'm sure these are about a hundred each from what a buddy told me.
That's not bad. Definitely cheaper than I could do just the mold for. Sorry I'm not much help.
 

·
Fuckin love chicken.
Joined
·
3,746 Posts
Night Owls!!!! Assemble!
 

·
Fuckin love chicken.
Joined
·
3,746 Posts
Check!

Whats up?
 
77941 - 77960 of 117827 Posts
Status
Not open for further replies.
Top