Yellow Bullet Forums banner

1 - 6 of 6 Posts

·
Registered
Joined
·
567 Posts
Discussion Starter #1
OK, so I need some wiring help/switch help. I'm working on getting factory power windows to work on a fox body. The motors each have 2 wires coming off of them. When I hook them to a cordless drill battery one way they go up, the other way they go down.

So how do I wire these to a nice looking switch??

Any suggestions on switches???

Thank you!!!
 

·
Registered
Joined
·
156 Posts
You'll either have to switch polarity using a 3 position,double pole, momentary toggle or rocker switch ( on/off/on) or two relays per side. If you use toggles or rocker, make sure they are rated high enough, somewhere around 25-30amp would be ideal.
If you need a diagram just say so and I'll throw one together.
 

·
Registered
Joined
·
156 Posts
Search momentary double pole switches (on/off/on) . If this is a race care, I'd use an Eaton or Honeywell toggle. There are nice rocker switches out there also not to mention the old GM switches. You'll just have to have the connector pigtail to connect them.
Again, if your just using a switch, make sure it will carry the load.
 
1 - 6 of 6 Posts
Top