Yellow Bullet Forums banner
1 - 11 of 11 Posts

· Registered
Joined
·
372 Posts
Yes but what about my friend Dal Sangha 5.80 seconds... I had planned to race top sportsman at this event and qualify at least top 3 but my friend Sonny Leonard has to look at my bullet after I set the current Comp A/AP National record a week earlier
 

· Banned
Joined
·
13,361 Posts
Discussion Starter · #3 ·
Good thing Sonny is a friend. Hate to think what those engines cost in Canadian money if you were a stranger ! :p

Dal did great, that 5.80/253 run looked so smooth.
I didn't stay for the last session last night, it started sprinkling with Dal just a few cars back in the lanes. Wasn't out there today, any results?
 

· Registered
Joined
·
372 Posts
Yes, my bullet cost me 80K US$$ in 1990... 70K Canadian $$ at the time as our dollar was superior to the US...I was told a couple years ago Jon Kaase had my bullet cloned for A/A record holder David Hughes. My bullet is special one of a kind as it has a 900 CI bore with a 540 CI stroke...The staff at Mission Raceway treated me as gold a week ago as I still have my class jacket from 1968 when by brothers and I towed across the train bridge to the track located across the road to the mall which was Mission raceway in '68
 

· Banned
Joined
·
13,361 Posts
Discussion Starter · #7 ·
The staff at Mission Raceway treated me as gold a week ago as I still have my class jacket from 1968 when by brothers and I towed across the train bridge to the track located across the road to the mall which was Mission raceway in '68
I remember going across the train bridge as a kid, I think the current bridge was built in the early 70's.
You saved about thirty grand just in the exchange rate !
 

· Registered
72 Nova, Caltrac's and Splite Mono's, 10.5 tire, 600+ci, NA!
Joined
·
2,936 Posts
Ken Sihota first to the 3's with a 3.98 @ 187 mph with his 5.2 bs nitrous set up! Congrats to him and his team!
CONGRATS KEN! GREAT JOB!
 
1 - 11 of 11 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top