Yellow Bullet Forums banner

21 - 40 of 1560 Posts

·
Registered
Joined
·
1,367 Posts
I'll throw a few pics into the pot...

9" narrowed 2" ea. side from stock width, notched frame rails,
Coilovers w/ Outlaw style Ladder Bars...

15x12's w/ 6" bs 29.5x10.5's



15x11's w/ 5.5" bs 315/60's

 

·
Embalmer
Joined
·
1,335 Posts
Here's Mine. Team Z 9inch narrowed about two+ inches each side. Stock Suspension setup. Has 15x10 Alumastars with 6 inch BS double beadlocked. With 295's for now. 275's going on for next year .
All Motor 406 SBF Brodix Neal's/Glide. been 9.68 @ 140 on the brakes with the chute out trying not to break out.
Been 144.90mph blowing the tires off running a 2.0 60ft and 10.00. had to pedal it. Should be in the 9.20/30's at close to 148 on a good hit. Hopefully tomorrow.

Dan Smith



 

·
ALL OUT
Joined
·
1,931 Posts
Yes you will have to trim the fender on the 315 on all the ones i have seen, unless you have quite the narrow rear and deep backspace I guess..


Nick Edelmans in progress hatch w/ narrowed 9" moser m9/coil over- 315 MT radial on 15X12 wheel with some wheelwell reshaping by Rob "rookie" Meyers





 

·
Registered
Joined
·
1,360 Posts

·
Registered
Joined
·
2,680 Posts
here is mine. i actually shortened it 2.5'' per side and imo was to much so i added a 1/2'' spacer on the wheels when i put it together. 15x10 and 6.5 bs with 315's





 

·
Registered
Joined
·
2,680 Posts
trimming the plastics till it fits lol. my buddy carpeted his tubs after he minitubbed his hatch. my notch carpet is in the winter plans
 
21 - 40 of 1560 Posts
Top