Yellow Bullet Forums banner
1 - 6 of 6 Posts

·
Registered
Joined
·
49 Posts
Discussion Starter · #1 ·
Any ideas? I need to crimp few 6an and 8 an fuel lines for my TS engine. While at PRI earls had a nice hydraulic press but costs $1800. I guess I could always send the hose out, but wondered if there's a cheaper alternative.

Thanks
 

·
Registered
Joined
·
2,642 Posts
Any decent Hydraulic hose shop should be able to do that for you. Just remember, in the Hydraulic industry they call AN, JIC.

Or you could have Fragola make them up for you and pressure test them too. http://fragolaperformancesystems.com/
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top