Yellow Bullet Forums banner

1 - 20 of 28 Posts

·
Registered
Joined
·
7,293 Posts
the wiper motor was right under the drain for the cowl & ran down into the motor. the dude turned the wiper on & it burned from the wiper motor to the fuse box & melted EVERY wire to each other along the way. it was one big plastic mess accross the harness. I cut out the wiper stuff, replaced what needed to go & zipped it all back up again. good to go.



Bob
 

·
Ronald Reagans Ultra Ego.
Joined
·
7,452 Posts
 

·
Registered
Joined
·
2,718 Posts
No shit you think that is bad, I will take some pics when I get to work Saturday. I work in a steel mill. That is very very clean work.....lol
 

·
YB Managing Editor
Joined
·
51,160 Posts
Here's how I clean shit up. All my jobs end up looking like this when I am done.. As you can see, NO HEAD BANGERS!!! ;)







 

·
Registered
Joined
·
27,956 Posts

Looks like the inside of some of the equipment I work on, yeah looks real nice now. Wait till one contactor fails and you have to trace the wires to find out which one it is. Especially if it's a dual voltage three phase unit like the equipment I work on.

Can be lots of fun!
 

·
Registered
Joined
·
10,404 Posts

Posted via Mobile Device
 
1 - 20 of 28 Posts
Top