Yellow Bullet Forums banner

1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
For those Manual Trans guys/gals running a NX Maximizer 5 and LNC2000... How do you have it setup so that you're not spraying while standing on the launch control, or during no lift shifts?

Will it read input from the Clutch Pedal switch, and cut the solenoids? Settings for that?

Guess I didn't even think of that until the other day after I dropped my car off for a clutch job and switch wiring. 😬
238826
 
1 - 1 of 1 Posts
Top