Yellow Bullet Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1,453 Posts
Discussion Starter · #1 ·
Just wondering has anyone else had this problem?? Last year,I had adjusters installed in the bottom bar of my ladder bars. twice now I've bent the adjuster towards the center of the car. the car has been corner weight and additional 23lbs adjusted to equal the rear weights on the car with the driver in the car. car wt 3270 had 53% 47% weight bias on the front. I've made no changes to the car and have run this set up for the last 2 years. now bending adjusters. any thoughts anyone.???? :smt100
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top