Yellow Bullet Forums banner

1 - 5 of 5 Posts

·
Registered
Joined
·
57 Posts
Discussion Starter #1
I have a BBC that took out a lifter and some of the debris put some small knicks in the leading edge of the connecting rod and at the small end. 1/8" across at most. They are good Manley rods in an engine that is making 1100hp. Do I need to replace the rod?
 

·
Registered
Joined
·
2,647 Posts
Post a pic if you can but it sounds like you now have a set of Manley rods with a bunch of stress risers in them---no doubt i would change if they were mine,,,,
 
1 - 5 of 5 Posts
Top