Yellow Bullet Forums banner

1 - 5 of 5 Posts

·
Registered
Joined
·
16,537 Posts
Discussion Starter #1
I just set up a 9" for a guy that provided Jegs' house brand gears and installation kit. I just managed to get a pattern and the specs are pretty good, but nothing about the kit was right. Even the pinion seal was wrong. There wasn't any pinion depth numbers, no 3rd member gasket, ring gear bolts were too short and too few shims.
Its a lot of work to do one and you'd like to have a good feeling about it, I don't have a good feeling at all about this one.
Rant done.
 

·
Registered
Joined
·
3,570 Posts
I am sure it is someone's stuff re-labeled BUT you get what you pay for. Not a knock on anyone's stuff but people need to stop buying a $2 cheeseburger expecting a steak. rant over.
 

·
Registered
Joined
·
16,537 Posts
Discussion Starter #3
Yesterday I had a jegs 9" and today a guy brought me a Mark Wliiams 9", there is a god after all, thank you! Nice to work on quality, even the steel feels better.
 
1 - 5 of 5 Posts
Top